|
Last Modified: 11-29-2007 |
1.6 A |
|
Service Category: Drivetrain |
Section: Automatic Transmission/Transaxle |
|
Model Year: 2008 |
Model: Sequoia |
Doc ID: RM0000013BZ01LX |
|
Title: AB60F AUTOMATIC TRANSMISSION / TRANSAXLE: TRANSMISSION WIRE: INSTALLATION (2008 Sequoia) |
INSTALLATION
1. INSTALL TRANSMISSION WIRE
(a) Coat the O-ring of the transmission wire connector with ATF.
|
(b) Install the 2 transmission wires with the 2 bolts.
Torque: 5.4 N·m (55 kgf·cm, 48 in·lbf)
|
|
(c) Connect the 2 transmission wire connectors.
HINT:
Push up the lever until the claw of the transmission wire connector makes a connection sound.
|
2. CONNECT TRANSMISSION WIRE
|
(a) Connect the 9 connectors to the solenoid valves.
|
(b) Connect the 2 ATF temperature sensors with the 2 clamps and 2 bolts.
Torque: 10 N·m (102 kgf·cm, 7 ft·lbf)
Torque: 11 N·m (112 kgf·cm, 8 ft·lbf)
HINT:
Each bolt length is indicated below.
12 mm (0.472 in.) for bolt A
36 mm (1.41 in.) for bolt B
3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY
(a) Coat a new O-ring with ATF and install it to the oil strainer.
|
(b) Install the oil strainer with the 4 bolts.
Torque: 10 N·m (102 kgf·cm, 7 ft·lbf)
|
4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY
|
(a) Install the 4 transmission oil cleaner magnets to the oil pan.
|
|
(b) Install a new gasket and the oil pan with the 12 bolts.
Torque: 7.4 N·m (75 kgf·cm, 65 in·lbf)
NOTICE:
-
Make sure that there is no oil or foreign matter on the gasket seal surface and oil pan contact surface.
-
Install the gasket so that there is no slack in the gasket, and make sure the seal surface's entire circumference is level.
-
Make sure that the 9 gasket drop prevention protrusions are set on the oil pan.
-
When tightening the oil pan, make sure that the gasket is not pinched between the gasket tightening area's sleeve and the transmission's seal surface.
|
5. ADD AUTOMATIC TRANSMISSION FLUID
6. ADJUST AUTOMATIC TRANSMISSION FLUID
(a) Adjust automatic transmission fluid
.
7. INSPECT FOR AUTOMATIC TRANSMISSION FLUID LEAK
|